Safety Operating Procedures for Laser Tube Cutting Machines

05/14

2020

　　 Laser tube cutting machine Analysis of Safe Operation Processes:

　　1. Observe the safety operating rules for universal laser tube cutting machines. Always start the laser strictly in accordance with the laser startup procedure.

　　2. Operators must be trained to become familiar with the structure and performance of laser tube cutting machines and to master the knowledge of the operating system.

　　3. Wear personal protective equipment as needed, and wear prescribed protective eyewear when working near laser beams.

　　4. Do not process the material before determining whether laser irradiation or heating is permissible, to avoid potential hazards such as smoke and vapor generation.

　　5. Laser tube cutting machine It can also be said that when a laser engraving machine is started, the operator must not leave the column or have others wait. If it is indeed necessary to leave, the machine should be stopped or the power switch turned off.

　　6. Keep the fire extinguisher in an easily accessible location; turn off the laser or close the shutter when not in use; do not place paper, cloth, or other flammable materials near unprotected laser beams.

　　7. If during this process it is discovered… Laser tube cutting machine In case of an abnormality, it should be stopped immediately, and the fault should be eliminated or reported to the supervisor in a timely manner.

　　8. Keep the laser, workbench, and surrounding area clean, organized, and free of oil or grease. Workpieces, sheets, and scrap materials must be stacked in accordance with regulations.

　　9. When performing maintenance, please adhere to high-voltage safety regulations. Every operation must be carried out in accordance with the relevant rules and procedures.

　　10. Laser tube cutting machine After starting the machine, you should manually jog the machine in the X and Y directions at a low speed to check for any abnormalities.

Laser tube cutting machine

　　11. After entering a new workpiece program, you should perform a trial run and check its operating status.

　　12. When operating the laser tube cutting machine, please pay close attention to the machine’s operation to prevent the cutter from exceeding its effective stroke or colliding with another machine.