Custom Laser Equipment: Environment and Maintenance of Laser Equipment, Laser Equipment – Laser Tube Cutting Machine
08/26
2020
Customized Storage Environment for Laser Equipment:
The laser is the core component of laser cutter maintenance. The laser’s low-temperature water system is set to… 22 degree, and the laser’s ambient temperature (air-conditioned room temperature) is below 26 degree. You can lower the ambient temperature of the laser environment (air‑conditioned room temperature) and reduce the relative humidity of the laser environment (air‑conditioned room). Alternatively, you can activate the cooling and dehumidification functions of the air conditioner to ensure that the ambient temperature of the laser does not exceed… 26 degree, while maintaining the relative humidity of the environment below 60 %.
Cooling water requirements:
Laser cutting machine maintenance also requires cooling water. We recommend that customers replace the laser cooling water every three months. The cooling water should be purified distilled water from Watsons. When adding tap water, be sure to monitor the conductivity value to prevent it from exceeding the specified limits.
Ensure the chassis is sealed:
The airtightness of the chassis also affects the maintenance of the laser cutting machine. Ensure that the cabinet doors are securely closed; that the lifting bolts on the top are fully tightened; and that the protective covers over unused communication and control interfaces at the rear of the chassis are properly installed and securely fastened. If, during operation, it becomes necessary to open the cabinet doors for any reason, you must first shut down the cooler before opening the doors. After closing the cabinet doors, follow the laser’s power-on sequence: first turn on the laser’s power switch and then proceed with operation. 60 For more than a few minutes, then turn on the chiller and wait until its actual temperature reaches within ± of the set temperature for the chilled water’s high‑ and low‑temperature water. 1 ℃, then the laser will be in a high‑pressure state.
That’s all. Suzhou Youshun Laser Equipment Co., Ltd. For the collected content, please contact us if needed.
Recommended Reading
If you are interested in our products, you can contact us.We will serve you with utmost sincerity.
Follow Us
Follow us
Contact Us
Service Hotline:+86 195 2273 7631
Official Email:sales@yosoon.cn
Headquarters Address: No. 521, Zhujiang Road, Huqiu District, Suzhou City, Jiangsu Province
Production Base: No. 16, Jiulong Road, Economic and Technological Development Zone, Suqian City, Jiangsu Province